Previous

Setting a Run Target

The Flow Engine flow includes several process steps. You can specify that the flow stop at a certain point with the Stop After command. When specified, the Flow Engine does not process beyond that point. You do not need to set a run target for typical Flow Engine use. By default, the Flow Engine processes all the steps.

To Set a Run Target

  1. From the Flow Engine, select Setup Stop After or click the Set Target toolbar button.

    figures/bstopaft.gif

    The Stop After dialog box appears, as shown in the “Stop After Dialog Box” figure of the “Menu Commands” chapter.

  2. Select the desired run target from the Stop After dialog box.

  3. Click OK.

    The Flow Engine stops processing after the specified point. The red stop sign visually indicates the run target.

Next