The Tools menu commands perform the following functions.
The commands on the Tools menu are the following.
| Post DRC | Allows you to run a desired DRC operation. |
| DRC | Runs DRC on selected objects. If nothing is selected, runs DRC on the whole design. |
| Delay | Displays delay information for selected component pins or nets. |
| Find | Finds a component, net, macro, site, or pin by name. If found, the object is highlighted. |
| Post Trace | Displays the TRACE dialog box. |
| Post Trace Summary | Displays the TRACE Summary dialog box, which lists information on each of the constraints that you selected for the TRACE run. |
| Trace | Runs TRACE on the selected constraint, then displays the TRACE Summary dialog box. |
