Previous

Relationally Placed Macros

This section lists the Relationally Placed Macros (RPMs) by family. RPMs are “soft” macros that contain relative location constraint (RLOC) information. For more details, see the “Relationally Placed Macros (RPMs)” section of the “Attributes, Constraints, and Carry Logic” chapter.

The following table lists RPMs (except for CY4_* carry mode symbols) by library for easy identification. Refer to the “Applicable Architectures” section of the “Xilinx Unified Libraries” chapter for information on the specific device architectures supported in each library.


NOTE

The CY4_* RPMs are not listed here. To see a list of predefined carry mode names and their corresponding symbols (CY4_*), refer to the “Carry Logic Primitives and Symbols” section of the “Attributes, Constraints, and Carry Logic” chapter.


Element Name
XC4000E
XC4000X
XC5200
Spartan
SpartanXL
Virtex
ACC4






ACC8






ACC16






ADD4






ADD8






ADD16






ADSU4






ADSU8






ADSU16






AND6






AND7






AND8






AND9






AND12






AND16






CC8CE






CC8CLE






CC8CLED






CC8RE






CC16CE






CC16CLE






CC16CLED






CC16RE






COMPMC8






COMPMC16






CY_INIT






CY_MUX






DECODE4






DECODE8






DECODE16






DECODE32






DECODE64






DEC_CC4






DEC_CC8






DEC_CC16






NAND6






NAND7






NAND8






NAND9






NAND12






NAND16






NOR6






NOR7






NOR8






NOR9






NOR12






NOR16






OR6






OR7






OR8






OR9






OR12






OR16






XNOR6






XNOR7






XNOR8






XNOR9






XOR6






XOR7






XOR8






XOR9







Next