Previous

IFDX_1

Input D Flip-Flop with Inverted Clock and Clock Enable

XC3000
XC4000E
XC4000X
XC5200
XC9000
Spartan
SpartanXL
Virtex
N/A
Macro
Macro
N/A
N/A
Macro
Macro
Macro

figures/x6014n.gif

The IFDX_1 D-type flip-flop is contained in an input/output block (IOB). The input (D) of the flip-flop is connected to an IPAD or an IOPAD. The D input also provides data input for the flip-flop, which synchronizes data entering the chip. The data on input D is loaded into the flip-flop during the High-to-Low clock (C) transition and appears at the output (Q). The clock input can be driven by internal logic or through another external pin. When the CE pin is Low, the output (Q) does not change.

The flip-flop is asynchronously cleared with Low output, when power is applied. FPGAs simulate power-on when global set/reset (GSR) is active. GSR (XC4000, Spartans) default to active-High but can be inverted by adding an inverter in front of the GSR input of the STARTUP symbol.

For information on legal IFDX, IFDX_1, ILDX, and ILDX_1 combinations, refer to the “ILDX, 4, 8, 16” section.

Inputs
Outputs
CE
D
C
Q
1
D

d
0
X
X
No Chg
d = state of D input one setup time prior to active clock transition

Figure 6.16 IFDX_1 Implementation XC4000, Spartans

Figure 6.17 IFDX_1 Implementation Virtex

Next