PIN2UCF Options

The -o and -r options are the only PIN2UCF option.

-o (Output File Name)

-o outfile[.ucf]

Specifies the name of the output UCF file for the design. The -o option is useful in the following ways.

• The UCF file used for the design has a different root name than the design name. By default, PIN2UCF writes a ncd_file.ucf file if
  -o is not specified. You can use this option to write the (append) pin locking constraints to the UCF file with a different root name.
  
  
• You want to write a UCF file to a different directory.
  
  

-r (Write to a Report File)

-r report_file_name

Writes the PIN2UCF report into the specified report file. If this option is not used, then a pinlock.rpt file is automatically written to the current directory.