Invoking Xilinx Development System Programs

You can start Xilinx Development System programs in the following ways.

• Enter a command at the UNIX^™ command line or on a DOS command line in an MS-DOS™ Prompt window (Windows 95^®) or a Command Prompt window (Windows NT^®).
  
  
• Invoke a command from one of the following Xilinx graphical applications.
  
  
  • Design Manager/Flow Engine
    
    
  • Foundation Project Manager
    
    
  • Timing Analyzer
    
    
  • FPGA Editor
    
    
  • Hardware Debugger
    
    
  • PROM File Formatter
    
    

Note: The graphical applications are described in separate manuals. This reference manual describes only the command line interface.