SPEEDPRINT Options

This section describes the options to the SPEEDPRINT command.

-min (Display Minimum Speed Data)

-min

The -m option displays minimum speed data for a device. This option overrides the -s option if both are used.

-s (Speed Grade)

-s [speed_grade]

The -s option with a speed_grade argument (for example, -4) displays data for the specified speed grade. If the -s option is omitted, delay data for the default, which is the fastest speed grade, is displayed.

-t (Specify Temperature)

-t temperature

The -t option specifies the operating die temperature in degrees Celsius. If this option is omitted, the worst-case temperature is used.

-v (Specify Voltage)

-v voltage

The -v option specifies the operating voltage of the device in volts. If this option is omitted, the worst-case voltage is used.